PR100/DDF007/MNT100 USB driver installation readme.txt
-----------------------------------------------

This readme describes the installation of the PR100 USB drivers on 
a Windows PC in order to use PRView via USB.

There are three files required to install the driver:
 - rndis_rs_pr100_ddf007_mnt100.inf
 - rndismpy.sys
 - usb8023y.sys

You need to install this driver if you want to use PRView together 
with a USB connection to the PR100/DDF007/MNT100.

To install this driver, follow the following steps:
 - On the Windows PC, right-click on "rndis_rs_pr100_ddf007_mnt100.inf" and select "install".
 - Disconnect and reconnect the USB cable from the PR100/DDF007/MNT100.
 - The driver installation menu pops up and guides you through the installation.
 - Check the USB connection by starting PRview and connecting via USB.
 

Troubleshooting
---------------
If the connection does not work, try the following :

A) Read the IP address that PRView is using for USB ( usually 169.254.1.1)
   from the PRView connection window and enter it into the driver: 
   - Start-Settings-Control Panel-System, Tab "Hardware"-Device manager.
   - In the device manager,  choose network adapter-RS USB Remote NDIS Network Device.
   - Right-click , choose Properties - Tab "extended".
   - Enter the network address and set it to valid.
   - Close and re-open PRView.
B) Disable Firewalls and virus scanners temporarily and check again.
C) Reboot your PC with the PR100/DD007/MNT100 USB cable disconnected.
   Re-connect the cable after the Windows have started.
     
       
       
        

